 |
|
|
- Effective control to Improve the quality of service due to network equipment centralization
- Preventing of time and cost waste by Network malfunction
- Preventing of surrounding serial effect by a device malfunction
- Demand stable and continuous service for operating network
- Minimizing malfunction time
|
| |
 |
|
|
- Korea type 1 and Malaysia type 5 power contact
- Supply 1 consol port and 1 WAN port
- Supply connect Static IP, PPPoE(ADSL) and DHCP
- Network remote control with WAN and Consol port
- Automatic power control with outer device status judgment
- Operating status check with status LED viewer
- Each power and serial consol connect status check with network
- Input power stability
- Supply various management tool by SMART POWERBAR NMS
- SPD module can prevent over voltage and current by lightning
|
| |
 |
|
After installed the power management, and then login into power management system.
|
|
Power Management viewer |
- You enable to retrieve some information from SPB, example name for SPB, code, IP address, status and etc.
|
|
We can set power reboot through UNCHECK particular power socket. Example |
- After we set power reboot with UNCHECK, the LED light will power off and power on again.
|
| |
 |
|
Beside use the SMART POWERBAR Management, we already tested with telnet into SPB which previously already assigned IP address. We tested with power ON/OFF, and reboot as well. |
Figure show power off the power socket 5 and 6
Figure show power on the power socket 5 and 6
Figure show power reboots for the power socket 5 and 6. The number 3 mean period time in second for restart the power connector.
|
| |
 |
|
Use CLI command to check the IP address for SPB |
|
|
Use netstat-rn for check the routing table in SPB |
|
| |
 |
|
Division |
Content |
| CPU |
PXA 255 400MHz |
| Main Memory |
32MB |
| Flash |
64MB |
| WAN |
10/100M based-T 1 port |
| Power |
AC 200 ~ 300V |
| Serial Interface |
RJ45 |
| Operating System |
SW O/S |
| Size |
435 * 300 * 60(mm) |
| Special H/W |
SPD 1 port(Pair) |
|
